Cross Bar Holder - Blind Hole Left End - Flat Mount

Stainless Steel Cross Bar Holder with Blind Hole Left, Flat Fix for Modular Balustrade

Flat mount cross bar infill holder suitable for left end positioning.

Options	Grade	Bar Ø (mm)	Code	Price (inc VAT)	Quantity
304 Grade	304	12	13.0832.000.12	£4.14	In stock

Options	Grade	Bar Ø (mm)	Code	Price (inc VAT)	Quantity
316 Grade	316	12	14.0832.000.12	£7.80	In stock

Tip: To view the product code and full product table on mobile please tilt your device to landscape.

	Available in 304 grade (interior) stainless steel.
	Available in 316 grade (exterior) stainless steel.
	To accept 12mm diameter bar.
	To a superb brushed 320 grit satin finish.
	Requires M6 x 25 Countersunk Hex Head Screw.
	Drill required for installation.
	Requires use of a Hex Head Key.

Flat surface fixing cross bar left end piece connector with blind hole to hold 12mm diameter stainless steel bar as a balustrade infill.

With a neat and tidy flush fitting for terminating the bar ends of a balustrade infill.

Available in either 304 (interior) grade or 316 (exterior) grade stainless steel.

Finished to a superb brushed 320 grit satin.

To mount on flat surfaces and square sections of stainless steel.

Quick and easy to install using a drill and hex head key.

M6x25 Countersunk Hex Head Screw for installation to stainless steel post.

Use of a Hex Head Key is required for installation.

Mark hole position on post. A small piece of masking tape will help with this. Drill 5mm diameter hole.	Tap the 5mm hole with a M6 tap.	Fix cross bar holder to the post with M6 countersunk screw.
Tighten with hex head key.	Insert rod into cross bar holder.	Secure with grub screw using hex head key.