Sta-Lok Former for Sta-Lok Swageless Fittings
Sta-Lok Former - 316 Stainless Steel
Sta-Lok Former - for the self assembly of Sta-Lok stainless steel wire rope terminals.
Sta-Lok Former - Swageless Fitting
| Options | Wire (mm) |
Pack Qty | Code | Price (inc VAT) | Quantity |
|---|---|---|---|---|---|
| 3mm Former | 3 | 5 | 115-03 | £11.32 | |
| 4mm Former | 4 | 5 | 115-04 | £11.45 | |
| 5mm Former | 5 | 5 | 115-05 | £13.44 | |
| 6mm Former | 6 | 5 | 115-06 | £14.32 | |
| 7mm Former | 7 | 5 | 115-07 | £17.04 | |
| 8mm Former | 8 | 2 | 115-08 | £8.16 | |
| 10mm Former | 10 | 2 | 115-10 | £10.44 | |
| 12mm Former | 12 | 1 | 115-12 | £12.00 | |
| 14mm Former | 14 | 1 | 115-14 | £19.76 | |
| 16mm Former | 16 | 1 | 115-16 | £23.92 | |
| 19mm Former | 19 | 1 | 115-19 | £95.23 | |
| 22mm Former | 22 | 1 | 115-22 | £100.25 | |
| 26mm Former | 26 | 1 | 115-26 | £115.99 |
Tip: To view the full product table on mobile please tilt your device to landscape.
Key Features:
 |
316 grade stainless steel. |
Recommended where Sta-Lok terminals are being re-used.
Sta-Lok formers are suitable for use with all wire constructions.
Product Information:
PDF Data Sheet
Download Sta-Lok Former Information
Sta-Lok Wire Connector Terminals - Technical Information - How to assemble
1. Cut wire rope and slide socket component over wire.
Wind tape around wire approx 12" (300mm) from end. This will prevent the socket from sliding down the wire.
TIP: If using a hacksaw to cut your wire rope, wind tape around wire to ensure a neat cut.
2. Unravel outer strands 2" to 3" (50-76mm) to expose central core.
TIP: Use a screwdriver to prise initial strands out of position.
3. Slide wedge component over central core of wire rope.
4. Reposition outer strands.
Turn outer strands either clockwise or anti-clockwise, depending on the lay of the wire, around the wedge. Ensure approx 1/8" (2-3mm) of the central core protrudes from the end of the wedge.
Outer strands should be evenly situated around the wedge. Care should be taken to ensure that a strand does not slip into the slit of the wedge.
TIP: Push the socket towards end of wire, while repositioning the outer strands, this will help control. When wire strands are in position, push socket firmly, as indicated to hold wires in position.
5. Final assembly.
Ensure former component sits in bottom of end fitting. Screw socket assembly into end fitting and tighten with spanners. The assembly is now complete.
TIP: Undue force is not required to terminate the wire.
Fitting instructions are supplied with each Terminal.
Questions & Answers
Reviews
