Wall and Floor Flange - Long - Chrome Finish - Bar Rail
Long Neck Flange Fixing with Polished Chrome Finish for 38.1mm Diameter Tube
Chrome wall/floor flange fixing designed for tube to be mounted over the long neck to provide a secure termination of 38.1mm Ø tube sections.
Wall and Floor Flange Fixing - Long Neck - Bar Railing
|Material||Code||Price (inc VAT)||Quantity|
Tip: To view the product code and full product table on mobile please tilt your device to landscape.
Key Features :
|To fit 38.1mm diameter tube.|
|Manufactured from Zintec/Protectan.|
|Tube can be attached using High Strength Fixative.|
|For installation you will require a few simple household tools.|
Flange fixing suitable for horizontal and vertical use, tube is secured into position using a high strength adhesive.
Designed to fit 38.1mm (1.5 inch) diameter tube.
Suitable for indoor use.
Three countersunk fixing points for quick and easy attachment to flat surfaces.
Can be mounted on to a multitude of surfaces if combined with the relevant fixings.
- Height (H): 40mm
- Base diameter (D): 75mm
- Base depth: 5mm
Our installation example below is for a bar foot rail using adhesive for a secure fixing.
Note: It is possible to attach tube without the use of high strength adhesive, this is dependent upon each individual installation. ie: if mounting between wall surface to wall surface.
1. Start by marking your mounting position, flange can be direct mounted on to timber, you may wish to drill pilot holes or use wall plugs (not supplied) for a secure fixing on different surfaces, simply tighten the screws until tight.
2. Apply a high strength adhesive (available separately) to the long neck and simply slide your tube into position until it sits neatly in the reception groove, wipe away any excess adhesive.
3. Allow fixative to set thoroughly, always ensure that your tube is secure before use.