- Balustrade Systems
- Glass Balustrade
- Frameless Glass Balustrade
- Ready Made Handrails
- Balustrade Wire Kits
- Wire Trellis Kits
- Cable Display Systems
- Interior Fittings
- Door Furniture & Fittings
- Wire Rope Fittings & Hardware
- Lifting Gear & Rigging Equipment
- Wire Rope Assemblies
- Wire Rope Tools & Cutters
- Stainless Steel Shackles
- Tie Bar Systems
Sta-Lok Stay Connector - Swageless Rigging Fittings - Stalok DIY Terminals
Sta-Lok Stay Connector
Sta-Lok Stay Connector - Self assembly stainless steel wire rope terminal.
All in 316 grade stainless steel. Connects two pieces of wire with no hassle.
Sta-Lok Stay Connector - Swageless Fitting
|Code||Price (inc VAT)||Quantity|
|316 grade stainless steel.|
Sta-Lok stay connector terminals are reusable and are supplied with 1x19 wedges as standard.
Wedges for 7 strand and Dyform can be purchased separately.
Sta-Lok Wire Connector Terminals - Technical Information - How to assemble
1. Cut wire rope and slide socket component over wire.
Wind tape around wire approx 12" (300mm) from end. This will prevent the socket from sliding down the wire.
TIP: If using a hacksaw to cut your wire rope, wind tape around wire to ensure a neat cut.
2. Unravel outer strands 2" to 3" (50-76mm) to expose central core.
TIP: Use a screwdriver to prise initial strands out of position.
3. Slide wedge component over central core of wire rope.
4. Reposition outer strands.
Turn outer strands either clockwise or anti-clockwise, depending on the lay of the wire, around the wedge. Ensure approx 1/8" (2-3mm) of the central core protrudes from the end of the wedge.
Outer strands should be evenly situated around the wedge. Care should be taken to ensure that a strand does not slip into the slit of the wedge.
TIP: Push the socket towards end of wire, while repositioning the outer strands, this will help control. When wire strands are in position, push socket firmly, as indicated to hold wires in position.
5. Final assembly.
Ensure former component sits in bottom of end fitting. Screw socket assembly into end fitting and tighten with spanners. The assembly is now complete.
TIP: Undue force is not required to terminate the wire.
Fitting instructions are supplied with each Terminal.