Wall & Floor Flange - Long Neck - Stainless Steel Finish

Wall and Floor Flange - Long - Bar Rail

Long Neck Flange Fixing with Stainless Steel Effect Finish for 38.1mm & 50.8mm Ø Tube

Flat surface mount wall/floor flange fixing, designed for tube to be mounted over the long neck to provide a secure termination of 38.1mm Ø and 50.8mm Ø bar rail tube sections.

Wall/Floor Flange - Long Neck - Dimensions

Wall/Floor Flange - Long Neck - Cross Section

Wall/Floor Flange - Long Neck - Position

Wall and Floor Flange Fixing - Long Neck - Bar Railing

Options	Finish	Tube Ø (mm)	D (mm)	H (mm)	Material	Code	Price (inc VAT)	Quantity
38.1mm Ø	Stainless Steel Effect	38.1	75	40	Zamak	11.0504.038.20	£10.70	In stock
50.8mm Ø	Stainless Steel Effect	50.8	100	50	Zamak	11.0504.050.20	£13.92	In stock

Tip: To view the product code and full product table on mobile please tilt your device to landscape.

Key Features :

	Stainless steel effect finish.
	Zamak construction.
	Option for 38.1mm diameter tube.
	Option for 50.8mm diameter tube.
	Tube can be attached using High Strength Fixative.
	For installation you will require a few simple household tools.

Flange fixing suitable for horizontal and vertical use, tube fits neatly over the long neck and can be secured in to position using a high strength adhesive.

Available for both 38.1mm (1.5 inch) and 50.8mm (2 inch) diameter stainless steel tube.

Manufactured from Zamak with a stainless steel effect finish.

Suitable for indoor use.

Three countersunk fixing points for quick and easy attachment to flat surfaces.

Can be mounted on to a multitude of surfaces if combined with the relevant fixings.

Zamak Construction

Zamak is a family of alloys with a base metal of zinc with elements of aluminium, magnesium and copper; offering great strength and durability.

Installation Advice

Our installation example below is for a bar foot rail using adhesive for a secure fixing.

Note: It is possible to attach tube without the use of high strength adhesive, this is dependent upon each individual installation. ie: if mounting between wall surface to wall surface.

1. Start by marking your mounting position, flange can be direct mounted on to timber, you may wish to drill pilot holes or use wall plugs (not supplied) for a secure fixing on different surfaces, simply tighten the screws until tight.

2. Apply a high strength adhesive (available separately) to the long neck and simply slide your tube into position until it sits neatly in the reception groove, wipe away any excess adhesive.

3. Allow fixative to set thoroughly, always ensure that your tube is secure before use.