Swageless Ball End Wire Rope Fitting - Stainless Steel

Wire Balustrade Swageless Ball End for 4mm Diameter 7x7 Cable

Quick and easy to DIY install ball end fitting for stainless steel wire rope, uses a simple compression design to hold wire rope securely in place, manufactured from 316 grade stainless steel.

Swageless Ball End - Wire Rope Fitting

Options Wire Ø
Grade Quantity Code Price (inc VAT) Quantity 
Swageless Ball End 4 316 1 CSB-040 £12.48
In stock

Tip: To view the product code and full product table on mobile please tilt your device to landscape.

Key Features

316 Grade Stainless Steel
316 grade stainless steel.
4mm 7x7 Stainless Steel Wire Rope
To fit 4mm 7x7 stainless steel wire rope.
Wrench/Spanner Set Required
Wrench/spanner set required for installation.

Wire rope end fitting with ball, sits inside our ball end socket to provide a secure termination for balustrade wire infill.

Compression design allows for a quick and easy installation with a few household tools.

Ball and socket design allows for 42 degree wire articulation on inclines and stairways.

Swageless Ball End Articulation

All component parts are manufactured from marine grade stainless steel, suitable for both indoor and outdoor use.

You may be interested in...

Installation Advice

For installation on to wire rope you will require a set of 8mm and 9mm open end wrenches/spanners and a good set of wire cutters for a neat and tidy cut.


Simply view or download our installation advice below.

Download Installation

Swageless Ball End Installation

1. Cut Wire

Measure and cut your wire to required length, we recommend using a set of good wire rope cutters to give you a neat and tidy cut.

Remember - measure twice, cut once! Please be as accurate as possible.

Cutting WIre

2. DIY Compression Fitting

The first step is to take apart your DIY compression fitting, simply unscrew the nose piece and remove the cone from inside.

DIY Compression Fitting

3. Thread Nose Piece onto Wire

Taking the blank cable end place the nose piece over the stainless steel wire rope (ensuring the thread end is towards the end of your wire).

Thread Nose Piece onto Wire

4. Thread Cone onto Wire

Thread the cone onto the wire and push into the threaded cone chamber.

Thread Cone onto Wire

5. Place Ball End onto Wire

Take the stainless steel body and push onto the wire, eventually bringing the three component parts together.

Turn in opposite directions to thread them together.

Place Ball End onto Wire

6. Secure Ball End Fitting

Using a pair of 8mm and 9mm spanners screw the two sections together until tight.

Secure Ball End Fitting
Swageless Ball End Wire Rope Fitting

Questions & Answers


Select your product
Show prices